ENGINES- CARS FOR SALE

THIS PAGE IS DEDICATED TO OFFERING FOR SALE DIFFERENT ENGINE BUILDS, AND PROJECT CARS, BOTH CUSTOMER'S AND OUR OWN.

NOTE: THIS HAS BEEN LISTED ON BaT, SO IT IS NO LONGER AVAILABLE

THIS IS A ONE-OFF COFFEE TABLE CREATED FOR SOMEONE WHO WOULD LIKE SOMETHING MORE THAN JUST A DISPLAY ENGINE.

ADDITIONAL INFO BELOW THE IMAGES

YOU CAN COPY AND PASTE THE VIDEO BELOW AS IT'S THE ONLY WAY I FIND TO LINK IT.

https://youtu.be/CeRGO6VjNtk

This table is constructed from a XJS 4.0 L all aluminum engine, and is very light.

Constructed in, and shipped from the USA!

It is a Functional, well balanced table, unlike most others!

All internals have been removed, the engine thoroughly cleaned and painted with PPG silver basecoat and several coats of clear for a resilient finish and a long lasting new appearance.
The inlets and outlets have been blocked off with polished aluminum plates and the feet are mounted into 1/2'' aluminum plates all of which are held on with studs and stainless acorn nuts.
There is a Jaguar motif on the timing cover where the crankshaft would normally protrude, and a 'leaper' emblem on the cam cover.
It retains the distributor wires and spark plugs, and the heavily modified intake has actual Hilborn 426 Hemi injector nozzles plumbed to a distribution block with stainless steel tubing.
The headers were created with stainless plate, and mandrel bent polished stainless tubing, and heat treated to give the effect that the engine might run.
The three feet are created so the table will set without rocking, and the foot pads are adjustable up to an inch higher, (with a 3/4'' open end wrench), and have rubber bottoms so as to not damage any nice flooring, and be somewhat gentle to carpet.
A 1/8'' plate is bolted to the bottom of the block where the oil pan was so it is flat and the engine sealed off.
There are 3 wheels that come with it so that it can be moved easily by one person, I have a video showing how easily the 3 wheels come off.

The single rear one is a caster, and the two on the side are stationary.

These, and any questions or more pictures desired can be sent by email if you want.

The glass top can be as shown, as round 48'' x 3/8'', or a 48'' x 3/8'' square, with either beveled edges or rounded.
It can be adjusted to near perfect level as the glass supports, which are 426 Hemi intake valves, which sit on set screws inside the aluminum plate supports that are bolted to the engine itself.
There is an Allen wrench included for that.
The table will be well crated, photographed, and shipped free anywhere in the lower 48 states, and the glass will be shipped to you from the closest distributor to your address which should reduce possibility of damage.
This is a one off piece, and won't be duplicated.

I may be creating similar engine tables, in the future, but just a bit different.

It's NOT a boat anchor!

Again, and questions or needs let me know by email..